For 3D printing powder manufacturing, it is made of titanium rod and titanium alloy rod.
The Metal Alloy Titanium Rod for Making 3D Printer Powder:
These items are used for: Medical use, aircraft and ship components
Standard of execution
Ti Titanium Bars And Titanium Alloy Barrs for Powder Production in Additive manufacturing (GB/T38973 2020)
Permissible size deviation:
Bar diameter deviations are allowed to be +-0.1mm
There is a maximum deviation from the bar length allowed of +-5 mm. A small bar length less than the nominal (10100) is acceptable, but it is not greater than 5%.
Each end of the bar must be cut flat. The cutting angle should not exceed 4mm.
Maximum bending distance of bar is 0.7mm/m
Appearance quality:
Clean the surface of bars. There should not be any oxide scales, cracks or folding. All local imperfections on the surface must be eliminated and cleaned. Maximum depth shall not exceed permissible deviation.
It is permitted for the surface of the bar to not exceed half the diameter deviation due to individual small scratches, indentations or other defects.
Payments & Transport:
Steel Alloy Titanium Rod To Make 3D Printer Powder Properties |
|
| Other Titles | Titium rod |
| N/A | |
| Compound Formula | Ti |
| Molecular Weight | N/A |
| Appearance | N/A |
| Melting Point | N/A |
| Solubility In Water | N/A |
| Density | N/A |
| Purity | N/A |
| Size | Individualized |
| Boling point | N/A |
| Specific Heat | N/A |
| Thermo Conductivity | N/A |
| Thermal Expansion | N/A |
| Young's Module | N/A |
| Exact Mass | N/A |
| Monoisotopic | N/A |
Titanium Rod To Make 3D Printing Powder Safety & Health Information |
|
| Safety Notice | N/A |
| Hazard Statements | N/A |
| Flashing Point | N/A |
| Hazard Codes | N/A |
| Risk Codes | N/A |
| Safety statements | N/A |
| RTECS # | N/A |
| Transport Information | N/A |
| WebK Germany | N/A |
Inquiry us
PREVIOUS Metal Alloy
NEXT Metal Alloy
This is a titanium sheet made from titanium plates with cold rolling. provides Titanium sheet in different sizes. High Purity Titanium Plate Titanium Steel Sheet: Standard: ASTM B265, ASME SB265, ASTM F67, ASTM F136, AMS 4902, AMS 4911…
Titanium Sputtering targets are used frequently in flat display coatings, hardware tool coating, decorative coat, semiconductor components and for semiconductor components. This is also one the key materials used to make integrated circuits. High P…
By sintering tungsten, a target made of tungsten is created. Tungsten targets can be made in different forms according to customer requirements. About Metal Alloy Fine Surface 19.15g/cm3 Tungsten Targets: Chemistry: Properties: Good r…